![]() ![]() ![]() Now, when a matchstick's placed in the channel, it will hopefully slide freely and without restriction. Use this DIY project as a gift or for hunting small game in the wilderness or dangerous predatory animals. The engine-powered crossbow is lightweight, low cost, and easy to make yourself. You should also be able to see the flight groove is slightly higher than the limb supports. This Bicycle Wheel Crossbow was built using a bicycle wheel, PVC pipe, and other materials to make a functional weapon. I chose to glue some fillets on the side for added support and durability. Now, the crossbow starts to come together as the tip of the gun rails are pressed firmly into a dab of hot glue on the inside of the bow.Ībout 30 seconds of steady pressure works well to keep the connection strong as the glue begins to cool. Don't worry about messing up the paint job … it's super easy to touch up make good as new. While you're at it, use a bit of sand paper to lightly round the edges of the barrel to help prevent the bowstring from fraying and breaking. You'll need to cut a very shallow groove for catching the bowstring, so try using a knife to carefully whittle out a small catch in the upper rails, in-line with the front of the pistol grip. To finish the frame, glue the "pistol grip" panels so they overhang slightly at the back. I left a matchstick in the flight channel to ensure I got the spacing right. I dropped the top down a touch, to form a little groove about half a matchstick deep, and it's important this flight channel stays clean, so ensure any excess glue gets removed.Īttach the handle support right behind the spacer, then glue the last rail in place. The outer rail needs just enough hot glue to secure the smaller, "rail spacer" flush with the tip.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |